MUX - Status Report Information Not Copying From Last Published

Products

• Clarity PPM SaaS
• Clarity PPM On Premise

Issue/Introduction

After the deletion of a draft Status Report, the previous published information is no longer copied.

1. Log into the Clarity MUX and open a Project. Go to "Status". Populate information in the Status Report, then "Preview" and "Publish" the report.
2. Exit an go back into the Status Report. Notice that the information from the previous Published report is copied into the new Status Report.
3. In the upper left side of the Status Report screen click "Reports" to go to the list of Status Reports.
4. Delete the latest Draft report.
5. Exit and go back into the Status Report module.

Expected Results:
The information from the Published Status Report should be populated in the new draft.

Actual Results:
The new Status Report is empty

Workaround:
None noted

Environment

Clarity 16.2.1, 16.2.2

Resolution

This was reviewed by the Development team and determined to be the expected result based on the design of the Status Reports. It is not recommended to delete a Status Report that is within Draft to avoid this issue.