How to display JCL and Input for a job using CA-SYSVIEW

book

Article ID: 36836

calendar_today

Updated On:

Products

CA SYSVIEW Performance Management NXBRIDGE - SYSYVIEW/ENDEVOR

Issue/Introduction

Question:

Can CA SYSVIEW show you the JCL from a jobs z/OS output?

Environment:

z/OS 1.13

Answer:

1. From the JOBSUM command, enter the JCL line command.

This will invoke ISPF EDIT to display the JCL and SYSIN data for the selected job.
The JCL line command is also available on the following primary commands:
LISTFILE, JHELDQUE, LISTINP, JJOBQUE, JOUTQUE

Additional Information:

If desired once the JCL has been updated, it can then be resubmitted by typing SUB on the Cmd line and hitting Enter.

Environment

Release: FAQSO.00200-14.1-SYSVIEW-Performance Management
Component: