Nutanix_Monitor probe profiles In Failure State

Products

• DX Unified Infrastructure Management (Nimsoft / UIM)

Issue/Introduction

While configuring the new monitoring profiles in nutanix_monitor using the admin console, the newly added profiles are displayed as 'Profile in failure state' after saving and reloading the probe configuration. Also, the respective resources are not loading up for these new profiles.

 

Environment

DX UIM 20.4.x / 23.4.x

nutanix_monitor probe => 1.60

Cause

Code defect

Resolution

This issue will be fixed in the next version of the nutanix_monitor probe (above 1.60).

The GA version should be released by the end of May 2024.