Error when saving configuration to profile for SD-WAN Edge

Products

• VMware VeloCloud SD-WAN with Premier Support
• VMWare SD-WAN
• VMware SD-WAN by VeloCloud
• VMware VeloCloud SD-WAN
• VMware VeloCloud SD-WAN Edge Appliance

Issue/Introduction

When saving any configuration for a profile, new configurations will not be saved with the following error is generated. 

"GE1 vlan {1} is not defined in the assigned network scheme"

or

"GE2 vlan {1} is not defined in the assigned network scheme"

Environment

SD-WAN
SD-WAN by VeloCloud

Cause

This is an expected behavior as per design of our product when 7x0 platform is part of the "Edge models" list under the interface section in the profile configuration, and VLAN 1 has been removed from the profile.

Resolution

Suggested workaround is to remove VCE7x0 platform assignment from Interfaces Module within the profile and save the configuration.

Additional Information

In case after removing 7x0 platform, if it does not work, additionally, change GE1 and GE2 from switched to routed if design permits.