DX UIM Converting Back secure hubs to Non-Secure Mode

Products

• DX Unified Infrastructure Management (Nimsoft / UIM)

Issue/Introduction

We have updated our UIM environment to a secure hub and now need to change it to unsecure. Can you please share the steps?

Environment

DX UIM any version

Resolution

To revert your secure environment to the non-secure state, you must downgrade all the robots and hubs in your secure environment by downloading and installing an older version of the robot and hub from the archive. Based on your setup, you can downgrade robots and hubs as follows:

• If your secure environment consists of standalone robots that are connected to a secure hub, then you must first downgrade all the standalone robots to non-secure robot version from your archive
• After you downgrade standalone robots, downgrade the robots running on the secure hub to non-secure robot version from your archive
• After you downgrade all the robots, downgrade the hubs to a non-secure hub version from your archive

Additional Information

https://techdocs.broadcom.com/us/en/ca-enterprise-software/it-operations-management/unified-infrastructure-management/23-4/upgrading/ca-uim-upgrade-step-3-deploy-the-upgrade/upgrade-uim-server/secure-hub-and-robot-ca-uim-9-sp1.html