PTF load job fails with RC 20 and IEC130I message

Products

• MICS Resource Management

Issue/Introduction

Issue: 

The PSPADD job that loads a PTF in the PSP libraries may fail with a return code 20 and messages similar to the ones below.

IEC130I SYSGO DD STATEMENT MISSING 
IEC141I 013-18,IGG0191B,{jobname},{step name},SYSTSIN,C95B,PDBE3F, 216 
sharedprefix.PSP.CNTL(@cccnnnn) 
IEA995I SYMPTOM DUMP OUTPUT nnn
SYSTEM COMPLETION CODE=013 REASON CODE=00000018 
TIME=hh.mm.ss SEQ=09403 CPU=0000 ASID=018A 
PSW AT TIME OF ERROR 075C1000 80E7A2C6 ILC 2 INTC 0D 
NO ACTIVE MODULE FOUND 
NAME=UNKNOWN 
DATA AT PSW 00E7A2C0 - 4100302C 0A0D010D A7E5014B 
AR/GR 0: 00AB4E88/00E7A5D0 1: 00000000/A4013000

 

Environment:  

The problem may occur at any CA MICS maintenance levels.

Cause: 

Client's HL Assembler is configured to use SYSGO DD statement instead of SYSLIN DD.

Resolution:

1.     Replace the SYSLIN with SYSGO on the statement 
//SYSLIN DD DSN=&SHRPFX..PSP.CNTL(@cccnnnn),DISP=SHR

       (cccnnnn is the product change number, i.e. CIC6797) 

 

2.     Rerun the PSPADD job.

 

Additional Information: 

Make the change for all steps in the PSPADD job that execute assembler (i.e. PGM=ASMA90).

Environment

Release: MICSAC00200-12.9-MICS-Resource Management-Accounting and Chargeback Opt
Component: