ALERT: Some images may not load properly within the Knowledge Base Article. If you see a broken image, please right-click and select 'Open image in a new tab'. We apologize for this inconvenience.

We already have an existing Developer ID provided to us by Spectrum support but we need to know how this can be imported to a new Spectroserver. How is this done?

book

Article ID: 35455

calendar_today

Updated On:

Products

CA Spectrum

Issue/Introduction



We already have an existing Developer ID provided to us by Spectrum support but we need to know how this can be imported to a new SpectroSERVER. How is this done?

Environment

Release:
Component: SPCCSS

Resolution

An existing Developer ID is added to your SpectroSERVER by doing the following:
  1. Go to the $SPECROOT/SS directory and type
  2. ../SS-Tools/SSdbload -d <developer filename>
Note: When first installed, SSdbsave is located in the $SPECROOT/SS-Tools directory. If its location is not set in a system path statement, you must use a full path, a relative path, move it, or link it to the same directory with the SpectroSERVER database.
 

Additional Information

Please reference the "Load Developer Information" section of the documentation for more information.