Alarm and QOS Retention periods

book

Article ID: 34657

calendar_today

Updated On:

Products

DX Infrastructure Management NIMSOFT PROBES

Issue/Introduction

How are Alarm and QOS Retention periods controlled. And How to I change them if I need to.

Environment

Any UIM Version

Resolution

Currently there are 3 retention period settings.
2 are located in the NAS probe
1 is located in the data_engine probe.

Below is detailed information
1) NAS stored data in two places, the local sql Lite database and the back end SQL databases used by UMP.
To see the retention time for the local SQL database please open the nas probe and go to the setup tab and look at the transaction log tab.


 


 

2) the second location is the retention period on the back end database for alarms.
Go into nas and the setup tab and go the nisbridge.



 

Usually most clients keep the two NAS settings the same. This is also what support would recommend.


3) The last is for QOS retention this is controlled by the data_engine.
Click on configure data_engine and go general tab you will see the QOS retention periods



 

Attachments

1558688419246000034657_sktwi1f5rjvs16flx.jpeg get_app
1558688417483000034657_sktwi1f5rjvs16flw.jpeg get_app
1558688415168000034657_sktwi1f5rjvs16flv.jpeg get_app
1558688413198000034657_sktwi1f5rjvs16flu.jpeg get_app
1558688410985000034657_sktwi1f5rjvs16flt.jpeg get_app
1558688407885000034657_sktwi1f5rjvs16fls.jpeg get_app