Can I create a super Package to deploy mutiple probes and configurations
Article ID: 34642
Updated On:
Products
NIMSOFT PROBES
DX Infrastructure Management
Issue/Introduction
Can I create a super Package to deploy mutiple probes and configurations
Environment
Release:
Component: CAUIM
Component: CAUIM
Resolution
Currently at this time this can not be done.
Each package that deploys a probe with a GUI as a file called info.pkg in it.
Currently the structure of this file only allows for a single GUI to be entered.
If this file is missing or not configured correctly you will only be able to get raw config to open.
Currently the best solution is to use the request.cfg files to install the probes needed for a target robot
then use a super package configuration only to deploy the changes.
Each package that deploys a probe with a GUI as a file called info.pkg in it.
Currently the structure of this file only allows for a single GUI to be entered.
If this file is missing or not configured correctly you will only be able to get raw config to open.
Currently the best solution is to use the request.cfg files to install the probes needed for a target robot
then use a super package configuration only to deploy the changes.
Additional Information
https://comm.support.ca.com/kb/how-to-create-a-ca-nimsoft-monitor-super-package-multiple-probes/kb000034670
Feedback
Yes
No
Powered by
