How to set Alarm_enrichment Loglevel and Logsize to capture information
search cancel

How to set Alarm_enrichment Loglevel and Logsize to capture information

book

Article ID: 34606

calendar_today

Updated On:

Products

DX Unified Infrastructure Management (Nimsoft / UIM)

Issue/Introduction

Proper location and key information for setting alarm_enrichment probe logsize and log levels

Environment

Any UIM Release

Resolution

The alarm_enrichment probe pulls all of its information from the NAS.cfg file.

In order to modify the Alarm_enrichment logsize and loglevel you need to edit the nas.cfg file using Raw Configure mode which is accessed by selecting the probe and holding down the SHIFT key and selecting rt-click->Raw Configure.

You will need to either edit or add the following keys to control this information and click Ok/Apply.

1) enrichment_loglevel = 0
2) enrichment_logsize =  100

After applying the settings using Raw Config, both the nas and alarm_enrichment probes will restart.  If the nas.cfg file is manually edited, these probes will need to be manually restarted.