How do I change the threshold for the queue size alarms that come from the hub?
Article ID: 34348
Updated On:
Products
DX Infrastructure Management
NIMSOFT PROBES
Issue/Introduction
Hub queue size alarms occur when the queue size threshold is exceeded. The threshold and severity of the alarm are configurable using Advanced Alarm Configuration in the hub Raw Configuration settings.
Environment
This article applies to all current versions of the hub probe.
9.x
9.x
Resolution
For alarms that say
The queue 'data_engine' is 10 MB. Check the hub configuration.
The "queue is growing" alarm threshold can be changed.
The default size (10 MB) can be overridden by setting the 'queue_growth_size' variable in the hub section of the hub probe Raw Configuration. The keyword may need to be added if it does not already exist in the configuration file.
The value is in MB.
The following parameters can be set to alarm when a queue in the hub starts growing.
queue_growth_severity
Specify the severity of the queue growth alarm.
queue_growth_size
Specify the size of the queue growth alarm.
The queue 'data_engine' is 10 MB. Check the hub configuration.
The "queue is growing" alarm threshold can be changed.
The default size (10 MB) can be overridden by setting the 'queue_growth_size' variable in the hub section of the hub probe Raw Configuration. The keyword may need to be added if it does not already exist in the configuration file.
The value is in MB.
The following parameters can be set to alarm when a queue in the hub starts growing.
queue_growth_severity
Specify the severity of the queue growth alarm.
queue_growth_size
Specify the size of the queue growth alarm.
Additional Information
Feedback
Yes
No
Powered by
