ALERT: Some images may not load properly within the Knowledge Base Article. If you see a broken image, please right-click and select 'Open image in a new tab'. We apologize for this inconvenience.
SLA report shows up empty when using "<" in the SLA name
Article ID: 34278
Updated On:
Products
DX Unified Infrastructure Management (Nimsoft / UIM)
NIMSOFT PROBES
Issue/Introduction
Problem:
After a new sla was created and calculated in the SLM portlet the sla report for it is empty when selected in the sla_report portlet.
Environment:
UMP 8.x
Cause:
If you create a SLA with a "<" symbol in the name, then the SLA Report will be blank.
Workaround:
You would need to rename your SLA in the SLM portlet to fix this issue. If you use a ">" or an "=" in the name then this issue does not occur.
Environment
Release:
Component: CAUIM
Component: CAUIM
Feedback
Yes
No
Powered by
