ALERT: Some images may not load properly within the Knowledge Base Article. If you see a broken image, please right-click and select 'Open image in a new tab'. We apologize for this inconvenience.
Web Admin Console does not show all installed robots or probes in the archive
Article ID: 34023
Updated On:
Products
DX Unified Infrastructure Management (Nimsoft / UIM)
NIMSOFT PROBES
Issue/Introduction
Problem:
We have approximately 200 robots reporting to this HUB. Also, while doing a search or filter by name or IP are shown only the 50 previously listed.
Also when I go to the archive I am not seeing all of my probes in the archive. What is causing this problem?
Solution:
This default was changed ot 350 in UIM 8.X but can be inceased as needed by following the below:
Navigate to the following on the Primary UIM server:
<Nimsoft>\probes\service\service_host\catalinaBase\conf\ids_services
In the file in ids_services.cfg, increase this value accordingly:
odata_max_results = 50
Restart the service_host probe
The web admin console should now show all of your robots.
<Nimsoft>\probes\service\service_host\catalinaBase\conf\ids_services
In the file in ids_services.cfg, increase this value accordingly:
odata_max_results = 50
Restart the service_host probe
The web admin console should now show all of your robots.
NOTE:
Both robot lists, search lists and probe lists are controlled by this key
Environment
Release: CNMSPP99000-7.6-Unified Infrastructure Mgmt-Server Pack-- On Prem
Component:
Component:
Feedback
Yes
No
Powered by
