ALERT: Some images may not load properly within the Knowledge Base Article. If you see a broken image, please right-click and select 'Open image in a new tab'. We apologize for this inconvenience.
cannot record e2e_appmon script "Check that the WTBho add-on is enabled"
Article ID: 33989
Updated On:
Products
DX Unified Infrastructure Management (Nimsoft / UIM)
NIMSOFT PROBES
Issue/Introduction
e2e_appmon Script cannot be recorded.
using IE, after the steps are recorded the following pop-us is seen:
Error: "Check that the WTBho add-on is enabled"
And the steps are not written in the script.
using IE, after the steps are recorded the following pop-us is seen:
Error: "Check that the WTBho add-on is enabled"
<Please see attached file for image>
And the steps are not written in the script.
Environment
Release:
Component: UIME2E
Component: UIME2E
Resolution
The WTBho add-on must be enabled.
2. Event though the WTBho add-on is enabled, this issue will also occur if Enable third-party browser extensions is NOT checked in IE:
Goto IE>>Settings>>Internet Options>>Advanced>>Under browsing>> Check the "Enable third-party browser extensions".
After enabling this option the script can be recorded correctly
<Please see attached file for image>
2. Event though the WTBho add-on is enabled, this issue will also occur if Enable third-party browser extensions is NOT checked in IE:
Goto IE>>Settings>>Internet Options>>Advanced>>Under browsing>> Check the "Enable third-party browser extensions".
<Please see attached file for image>
After enabling this option the script can be recorded correctly
Attachments
Feedback
Yes
No
Powered by
