nas probe alarm replication does not properly work in circular loop replication
Article ID: 33912
Updated On:
Products
DX Infrastructure Management
NIMSOFT PROBES
Issue/Introduction
Background:
Here is an example setup.
NAS #1 - NMS (Main)
NAS #2 - NMS (Backup)
NAS #3 - A tenant dedicated hub.
Replication setup
NAS #1 <-> NAS #2 (Bi-directional)
NAS #3 --> NAS #1 (One way)
NAS #3 --> NAS #2 (One way)
Circular loop in the transfer process was involved in this setup.
When 3 or more NASes are involved in the circular type replication, please enable "Relay forwarded alarm events" in all NAS probes.
https://wiki.ca.com/pages/viewpage.action?pageId=154179057
Without this flag, NAS does not automatically attempt to recognize circularity. The flag allows all NASes to recognize when an alarm has made a circular loop in the transfer process.
?
Here is an example setup.
NAS #1 - NMS (Main)
NAS #2 - NMS (Backup)
NAS #3 - A tenant dedicated hub.
Replication setup
NAS #1 <-> NAS #2 (Bi-directional)
NAS #3 --> NAS #1 (One way)
NAS #3 --> NAS #2 (One way)
Circular loop in the transfer process was involved in this setup.
When 3 or more NASes are involved in the circular type replication, please enable "Relay forwarded alarm events" in all NAS probes.
https://wiki.ca.com/pages/viewpage.action?pageId=154179057
Without this flag, NAS does not automatically attempt to recognize circularity. The flag allows all NASes to recognize when an alarm has made a circular loop in the transfer process.
?
Environment
Release:
Component: UIMNAS
Component: UIMNAS
Feedback
Yes
No
Powered by
