Unable to select correct switch when adding hardware VTEP binding when multiple hardware VTEPs are used

Products

• VMware NSX

Issue/Introduction

• The switch selection box in the "manage hardware binding" dialog of a logical switch does not display all switches when clicking on the disclosure triangle of the combo box.
• The default value of the switch selection box also does not match the hardware VTEP section that you are trying to add a binding for.
  
  

Environment

VMware NSX Data Center for vSphere 6.4.x, versions below 6.4.6

Cause

A default value is inserted into the switch selection box and this default value is used as a filter for the selections available in the combo box.
As such not all available switches are listed in the selection

Resolution

This issue is resolved in VMware NSX Data Center for vSphere 6.4.6

Workaround:
After clicking on "add", remove the default value from the newly added switch selection box. This allows you to select the correct switches.