In Spectrum If a discovery has been started is there any way to stop it if required

Article Id: 33310
Status: Published
Updated On: 30-04-2019 08:32
Legacy Id: TEC1748506
Products:
CA Spectrum - OneClick CA Spectrum - Reporting CA Spectrum - Integrations CA Spectrum - Alarms & Event Management
Issue/Introduction:



In Spectrum how can i stop a discovery while it is running?

Environment:

Release:
Component:

Resolution:

If you need to stop a running discovery this can be done by:

  1. From the OneClick console select the VNM model.
  2. Select the sub view AutoDiscovery Control.
  3. Select Debug Options.
  4. Then select Abort Discovery.