I made changes to the ACFFDR, did the LLA refresh, and ACF2 NEWMOD but the changes are not being picked up, what would cause this?
Article ID: 33304
Updated On:
Products
Issue/Introduction
Changes were made to the ACFFDR, an LLA refresh was done, followed by ACF2 NEWMOD but the changes are not being picked up, what would cause this?
Resolution
The modify ACF2 NEWMOD command will dynamically reload the ACFFDR from the LINKLIST, however if there are multiple copies the first ACFFDR module in the LINKLIST will be reloaded.
Sites can use TSO ISRDDN diagnostic utility to check to see if there are multiple copies of the ACFFDR in the linklist.
This can be done as follows from ISPF.
- Issue command TSO ISRDDN
- issue command LINKLIST
- Issue command MEMBER ACFFDR
- If you get a warning... Type YES to proceed . . prompt enter Yes
If there are multiple copies of the ACFFDR in the LINKLIST be sure that the desired changed ACFFDR is the first copy
in the order of LINKLIST libraries. Delete or move any older versions as needed.
Feedback
