Show ip bgp neighbor <neighbor-ip > route command does not work on 6.4.6

Products

• VMware NSX

Issue/Introduction

• Running command show ip bgp neighbors < neighbor-ip> route does not give any output.
• This issue is observed even after you re-deploy the edge or failover the edge.
• show ip route bgp will show all the routes advertised by the neighbor.

Resolution

This issue is resolved in VMware NSX Data Center for vSphere 6.4.7 and higher

Workaround:

Run "show ip bgp | grep <neighbor ip>" command, instead of "show ip bgp neighbors < neighbor-ip> route"

Additional Information

Impact/Risks:
No impact on the datapath