ALERT: Some images may not load properly within the Knowledge Base Article. If you see a broken image, please right-click and select 'Open image in a new tab'. We apologize for this inconvenience.
How can I start or stop the TIM from the command line?
Article ID: 33228
Updated On:
Products
CA Application Performance Management Agent (APM / Wily / Introscope)
INTROSCOPE
Issue/Introduction
Question:
Is it possible to start or stop the TIM process from the command line without using the UI?
Answer:
Run the following command to start the TIM process
/etc/rc.d/rc.tim start
Run the following command to stop the TIM process
/etc/rc.d/rc.tim stop
Additional Information:
https://communities.ca.com/community/ca-apm/blog/2015/06/17/tim-fine-tuning-the-tim-incl-os
Environment
Release: CEMUGD00200-9.7-Introscope to CA Application-Performance Management-Upgrade Main
Component:
Component:
Feedback
Yes
No
Powered by
