Smarts IP: The field SNMPSTPStatus is not populated in Smarts and so STPNODES are not being monitored for faults
Article ID: 331678
Updated On:
Products
VMware Smart Assurance
Issue/Introduction
Symptoms:
Despite setting EnableSTPMonitoring to TRUE in discovery.conf the field SNMPSTPStatus remains blank
Despite setting EnableSTPMonitoring to TRUE in discovery.conf the field SNMPSTPStatus remains blank
Environment
VMware Smart Assurance - SMARTS
Cause
STP node status is available through the following oid:
SNMPSTPStatus = "1.3.6.1.2.1.17.2.15.1.3"
Thats what the instrumentation class STPNode_Fault polls for. For the device in question when the oid is walked there is no value returned so smarts wont monitor STP Status
SNMPSTPStatus = "1.3.6.1.2.1.17.2.15.1.3"
Thats what the instrumentation class STPNode_Fault polls for. For the device in question when the oid is walked there is no value returned so smarts wont monitor STP Status
Resolution
If you believe there is an issue on the Smarts side please open a service request as it might be necessary to debug further or recertify the device
In this instance the issue was on the device side
In this instance the issue was on the device side
Feedback
Yes
No
Powered by
