Smarts IP: Discovery of the pending list never starts; Why can't we discover the pending list in Smarts IP?
Article ID: 331589
Updated On:
Products
VMware Smart Assurance
Issue/Introduction
Symptoms:
The pending list is never depleted throughout the day. Smarts DMAC is set for running the pending list every hour.
We can remove a device from the list, but right clicking on it, and starting a discovery- doesn't work. The command line "sm_tpmgr -s --discover-pending" also does not start discovery of pending list, confirmed via tailing the log.
The pending list is never depleted throughout the day. Smarts DMAC is set for running the pending list every hour.
We can remove a device from the list, but right clicking on it, and starting a discovery- doesn't work. The command line "sm_tpmgr -s --discover-pending" also does not start discovery of pending list, confirmed via tailing the log.
Environment
VMware Smart Assurance - SMARTS
Resolution
The Default parameters were being used in /etc/security/limits.conf. Once maximum file descriptor limits were increased for smarts user and restarted domains the issue was resolved.
To up the user-based limits in Linux the following lines were added/changed in /etc/security/limits.conf:
smarts hard nofile 65534
smarts soft nofile 65534
smarts hard nproc 65534
smarts soft nproc 65534
To up the user-based limits in Linux the following lines were added/changed in /etc/security/limits.conf:
smarts hard nofile 65534
smarts soft nofile 65534
smarts hard nproc 65534
smarts soft nproc 65534
Feedback
Yes
No
Powered by
