Smarts NCM: How can I grant a group(s) permission to only a use Cut-Through?
Article ID: 331315
Updated On:
Products
Environment
Resolution
How can I assign cut-through only permissions to a Smarts NCM group?
Complete the following actions to grant group permissions in Smarts NCM to use the Cut-through command:
1. Log into Smarts NCM.
2. Access System Administration Console by selecting it from the Tools navigation bar or by pressing F4.
3. In the System Administrator screen navigate to the System Groups under System Administration Global User Management.
4. In the right panel select the Group you want to grant access to perform Cut-through permissions on and then click on Permissions in the lower left corner.
5. An Access Control Administration screen will present itself and will have 4 groups of permissions to manage System, Network, Workspace, and Device.
a. System Permissions- Nothing checked
b. Network Permissions -
i. Make sure the network where the user needs to perform the cut-through is a selected resource by clicking on Network Permissions on the left panel and clicking Manage in the lower right hand corner of the right panel.
ii. Select the network in the left panel and on the right panel check the following permissions: Only check the following listed.
1. Under Network- View
2. Under Device Edit; Manage OS; Run Cut-throughs
3. Under Job - Nothing should be checked.
4. Under View - Nothing should be checked.
c. Workspace Permissions - Default or if you have created a workspace this must be configured.
1. Under Workspace - View should be checked.
2. Under Device - Run Cut-Throughs, Manage OS, Edit should be checked.
3. Under Job nothing should be checked.
d. Device Permissions Nothing selected
Feedback
