Partial config pulled for Nexus devices

Products

• VMware Smart Assurance

Issue/Introduction

Symptoms:


Partial config pulled for Nexus 5k model devices. Following error is seen in commmgr.log with regards to running config of Nexus 5596 device:

Oct 11 06:52:32 -564185344/pull(9967882)#1: State match:[1001][01;34m[(?!\*)(?!#)^\S+#\s*(?!#)][00m 1 5~~no logging console~~~~~~~[01;34m[<device name># ][00mshow running-config~~~

Environment

NCM 10.1.x

Cause

There's a prompt mismatch between the device configuration and NCM regex for EnablePromptState. 

Resolution

Please implement the modified CiscoNexusPrompts.xml file attached to the article using the below steps:

1. Make the following directories in NCM Device Server installation if it doesn't already exist.
   • $VOYENCE_HOME/custompackage/pkgxml/CiscoNexus
2.   Copy the attached CiscoNexusPrompts.xml file to $VOYENCE_HOME/custompackage/pkgxml/CiscoNexus directory
3. Perform a service voyence restart.
4. Clear the cache for the Nexus devices and run a pull config job.
5. If the entire config is not shown post step 4, please proceed to delete the devices and discover it again in NCM & perform a pull operation.