Baseline Variance in TSV shows as the Sum of Baseline Usage and Total Usage

Article Id: 32864
Status: Published
Updated On: 14-02-2018 08:20
Legacy Id: TEC1954108
Products:
CLARITY PPM FOR ITG , Clarity PPM On Premise , CLARITY PPM FEDERAL , Clarity PPM SaaS , Clarity PPM SaaS - Application , Clarity PPM SaaS - Application , Clarity PPM On Premise
Issue/Introduction:

Problem:  

Base on the documentation, the Baseline Variance should be Baseline Usage minus Total Usage, but when placed on the TSV on various portlets (including Team Detail, Weekly Detail and Resource Workloads) the Baseline Variance shows as Baseline Usage plus Total Usage.  

Steps to Reproduce: 

  1. Create a Project, add a resource to the Team and assign them to a task, add 12 ETC for next week (from this the total Usage is 12 ETC + 0 Actuals = 12 Total Usage hours) 
  2. Create a Baseline on the Project. (this makes the Baseline Usage = 12 hours) 
  3. Go to Resource Planning > Weekly Detail portlet, and configure Total Usage, Baseline Usage and Baseline Variance to the Time Scale View 
Expected Result: Baseline Usage to show 0 hours on the Time Scale 
Actual Result:     Baseline Usage shows 24 hours on the Time Scale

Environment: 

Applies to all supported releases of PPM

Cause:

Caused by CLRT-75716

Resolution: 

After review, it has been determined this issue will not be fixed at this time.

Additional Information:

Reference the Customer Reported Defect Resolution Policy for CA PPM

Environment:

Release: ESPCLA99000-13.3-Clarity-Extended Support Plus
Component: