Smarts SAM: Is there a DMCTL Command to determine if an Escalation Policy is ENABLED?

Products

• VMware Smart Assurance

Issue/Introduction

Symptoms:


Is there a DMCTL Command to determine if a Smarts SAM Escalation Policy is ENABLED?
Is there a DMCTL Command to determine if a Smarts SAM Escalation Policy is DISABLED?

How can I determine the current status of a Smarts SAM Escalation Policy via the DMCTL command line interface?

Environment

VMware Smart Assurance - SMARTS

Resolution

You can get a list of your current Smarts SAM Escalation Policies using the following command:

./dmctl -s <SAM DOMAIN> getI ICS_AutoActionPolicy

You can then use the following command to check the current status of any of the escalation policies in the list derived from the above command:

./dmctl -s <SAM DOMAIN> get ICS_AutoActionPolicy::<Policy Name>::Enabled