Exclude hosts from registration in vSphere Replication
Article ID: 327271
Updated On:
Products
Issue/Introduction
Prior to vSphere Replication 8.7, all hosts visible to the VR appliance would be automatic candidates for registration to be used by VR.
When using vSphere Replication, all hosts within the vCenter Server inventory are registered automatically.
If you want to exclude hosts or a cluster of hosts under a given cluster or datacenter from registration in vSphere Replication, you can tag them with the com.vmware.vr.disallowedHost tag. This is valid for the incoming replications on the target site. The tagged hosts are still used for outgoing replications and the virtual machines on the disallowed hosts can be replicated.
Environment
Resolution
Tag the host or cluster with com.vmware.vr.disallowedHost
VC:Host>Summary>Tags>Assign>Add Tag - com.vmware.vr.disallowedHost : {Desc: Indicates that a given host (or hosts under a given cluster or datacenter) should not be used by vSphere Replication }(do not rename)
After the tags are added, you will need to restart the services on the appliance to get the changes to take effect or power off and on the appliance.
To restart all the services use the following steps:
1. Log in to the VRMS Appliance Management Interface as admin.
2. In the VRMS Appliance Management Interface, click Services.
3. The Services page displays a table of the installed services that can be sorted by name, startup type, and state.
4. Select a service and click Restart.
Additional Information
Feedback
