Logical Network Connectivity UI does not display any graph, but just reports "Too Many Data"
search cancel

Logical Network Connectivity UI does not display any graph, but just reports "Too Many Data"

book

Article ID: 325097

calendar_today

Updated On:

Products

VMware NSX

Issue/Introduction

Symptoms:
  • Logical Network Connectivity in the User Interface (UI) fails to display graphs.
  • It just reports the message similar to:

    Too Many Data.


Environment

VMware NSX-T Data Center 2.x
VMware NSX-T Data Center

Cause

This issue occurs due to a known User Interface (UI) bug that should error out only when number of logical ports number exceed 20, but it incorrectly gives an error when number of logical ports exceeds 8.

Resolution

This issue is resolved in VMware NSX-T Data Center 2.4, available at VMware Downloads.