Catalyst connector 3.4.1 installation error on Windows 2012 server

book

Article ID: 32450

calendar_today

Updated On:

Products

CA Service Operations Insight (SOI)

Issue/Introduction

Problem:

We have a requirement to install CA Catalyst r3.4.1 and SCOM Connector version 4.2.00 on a Windows 2012 R2. While installing CA Catalyst r3.4.1 installer on windows 2012 R2 OS we get following error :- 

Installer User Interface Mode Not Supported:- 

The installer cannot run in this UI Mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The valid UI modes identifies are GUI, Console an Silent. 

 

Environment:

Windows 2012 R2

Catalyst Container 3.4.1

 

Resolution:

1) Please change the compatibility mode to Windows 7 as shown in the below screenshot for \Disk1\InstaData\Windows\VM\Install.exe binary.

<Please see attached file for image>

11.jpg

 

2) Then right click on ‘\Disk1\catalyst_install.bat’ file -> select 'Run as Administrator' as shown in the below picture

<Please see attached file for image>

12.jpg

3) Now, the installer executes and installs the catalyst container

Environment

Release: SAMBDL99000-3.3-Spectrum-Service Assurance Manager-Promotional Bundle
Component:

Attachments

1558696432532000032450_sktwi1f5rjvs16nfm.jpeg get_app
1558696430420000032450_sktwi1f5rjvs16nfl.jpeg get_app