Doing a 'Save As' from MSP to CA PPM fails if a project is created in MSP, has PPM resources staffed and assigned to new tasks, then baselined in MSP.
Steps to Reproduce:
Prerequisite: an active connection is already established between CA PPM and MSP by opening a project from CA PPM and closing the project without closing out of MSP completely.
Expected Result: Project save is successful
Actual Result: Project save fails
This issue applies to 14.3 with the new driver, it is not reproducible on 14.2 and other lower versions
Caused by CLRT-79005
Resolved in CA PPM 14.4.
Clear baseline in MSP and baseline in PPM once the project saves
Reference CA PPM Resolved Defects Index for 14.4.
Release: ESPCLA99000-14.3-Clarity-Extended Support Plus