NSX V2T - Resolve Configuration phase shows Input field shows persistent error "Previously submitted input(s) are not valid."

Products

• VMware NSX

Issue/Introduction

Resolve Configuration phase of V2T migration shows Input field "An NSX-T Edge node will provide HA redundancy for edge replacing NSX-v edge. Select an unused transport node for this Edge node." with persistent error "Previously submitted input(s) are not valid." There may be multiple copies of the same Input field, with some fields not allowing selection of Edges deployed after Migration was started

Environment

VMware NSX-T Data Center 3.x
VMware NSX-T Data Center

Cause

At the time the NSX-V configuration with HA ESG was Imported, there was only 1 Edge node deployed on NSX-T. NSX-T Edges deployed after Migration began do not appear in drop down list for the initial Input field

Resolution

Deploy a second Edge node in NSX-T, and select "Cancel Migration" in the Migration window.
After restarting the migration, new Edge nodes will be listed for the HA Edge node selection.