Edge node without BGP enabled may raise alarms continuously indicating that it is unable to get BGP neighbor status.
book
Article ID: 315184
calendar_today
Updated On:
Products
VMware NSX
Issue/Introduction
Edge logs may indicate an error where they are unable to get BGP neighbor status, even when there is no BGP neighbor configured. This message may repeat continually.
Below is an example of what may be seen in the Edge logs: 2021-02-11T21:54:06.464Z edge1.poc.local NSX 763 - [nsx@6876 comp="nsx-edge" subcomp="agg-service" tid="3308" level="ERROR" errorCode="MPA13791"] [GetFrrBgpNeighborStatus] Failed to get BGP neighbors response
Resolution
No functional impact. Cosmetic only. There is no workaround. This will be fixed in a future release.