ESXi host goes into boot-loop when NSX-T is prep on the host
Article ID: 311859
Updated On:
Products
VMware NSX
VMware vSphere ESXi
Issue/Introduction
Symptoms:
After a host is prep for NSX-T, the host goes into a boot loop if a reboot is perform.
After a host is prep for NSX-T, the host goes into a boot loop if a reboot is perform.
Environment
VMware NSX-T Data Center 3.x
VMware NSX-T Data Center
VMware NSX-T Data Center 4.x
VMware NSX-T Data Center
VMware NSX-T Data Center 4.x
Cause
Verify if the host is booting from SAN which may have slow performance and a third party vendor ESXi image is used which contains additonal drivers.
When booting from a disk (including SAN, iSCSI, etc., which the bootloader sees as disks), there is a 5-minute timeout for the whole boot. It can take more than 5 minutes when all the VIBs are included. Hence, the host goes into a bootloop.
When booting from a disk (including SAN, iSCSI, etc., which the bootloader sees as disks), there is a 5-minute timeout for the whole boot. It can take more than 5 minutes when all the VIBs are included. Hence, the host goes into a bootloop.
Resolution
Use a vanilla Esxi image and only add the require VIBs/Drivers to build the custom image to install for the host.
Feedback
Yes
No
Powered by
