Incomplete configuration output when using QADD driver
Article ID: 303537
Updated On:
Products
VMware Smart Assurance
Issue/Introduction
Incomplete configuration output observed in Smarts Network Configuration Manager (Smarts NCM) when using QADD driver
Following is seen in Smarts NCM session.log with debug enabled:
getCurrentState - State match:[1004][ogin"ser\s*[Nn]ame:][login]
Environment
VMware Smart Assurance - NCM
Cause
Driver changes state to login after seeing "set admin auth banner console login" or any phrase containing "login" during show config.
Resolution
Ensure that the login prompt in the QADD driver configuration ends with a colon (":"), as in the following:
login:
Feedback
Yes
No
Powered by
