IAS commands cheat sheet
search cancel

IAS commands cheat sheet

book

Article ID: 29799

calendar_today

Updated On:

Products

CA 7 Workload Automation

Issue/Introduction

Listed below are helpful commands that can be passed to IAS.

Resolution

The following command should be used when you want to dynamically add a new agent to your IAS environment. This command is done after you have defined the new agent(s) to the IASAGENT file:

 /IAS,FUNC=RECONFIG

 

The following command should be used to print the IAS log. This command is used to collect the iaslog for debugging I problems and should only be done at the request of CA Support.

/IAS,FUNC=LOGPRINT,LOGDD=IASLOG

 

The following command should be used to stop and start IAS communications. This command should rarely be used. An example for the use of this command is to temporarily stop submitting jobs to all agents.

/IAS,FUNC=STOPCOM

/IAS,FUNC=STARTCOM