BMP and DL/1 Batch is not monitored with IMSICEPT and IMSSSA is YES

Products

• Mainframe Application Tuner

Issue/Introduction

Are there any other settings/definitions to monitor BMP and IMS Batch ? MATUNE does not monitor IMS job with following definitions.

HLQ.UTRPARM(TUNSSP00)
 IMSICEPT=YES
 IMSSSA=YES

Specify target name: (Job required)                                            
    Job ===> jobname  Step ===>          Pstep ===>          Prog ===>          
     Multi-Step Monitoring ===> YES  (YES or NO)                                  

Specify parameters for target job name:   
  Monitor entire step ===> YES    (Yes or No)          

 

Environment

Release 12.0

Resolution

If MATUNE does not monitor BMP or IMS Batch job with "Multi-Step Monitoring=>YES", try to set  "Multi-Step Monitoring=>NO" and specify "Job", "Step", "Pstep".

HLQ.UTRPARM(TUNSSP00)
 IMSICEPT=YES
 IMSSSA=YES

Specify target name: (Job required)                                            
    Job ===> jobname  Step ===> stepname  Pstep ===> pstepname   Prog ===>          
     Multi-Step Monitoring ===> NO  (YES or NO)                                  

Specify parameters for target job name:   
  Monitor entire step ===> NO    (Yes or No)