Configuring additional nodes for gateway cluster

Products

• CA API Gateway

Issue/Introduction

Software base install of the API Gateway v11 running on RHEL 8 with mySQL v8.

Looking for steps of adding a 2nd node.

Environment

Gateway 10.x, 11.x

Cause

Information knowledge article

Resolution

Expanding gateway cluster by adding additional processor nodes

1. When setting up the new NODE the cluster password MUST match the value used on the first gateway 
2. mysql accounts and privileges must be setup to allow the new gateway node to connect and process mysql call in the ssg db  - info on mysql located in the first link 

Configuring the First Processing Node & Software Gateways (section)

https://techdocs.broadcom.com/us/en/ca-enterprise-software/layer7-api-management/api-gateway/11-0/install-configure-upgrade/configure-a-gateway-cluster/configuring-the-first-processing-node.html’

Configuring Subsequent Processing Nodes

https://techdocs.broadcom.com/us/en/ca-enterprise-software/layer7-api-management/api-gateway/11-0/install-configure-upgrade/configure-a-gateway-cluster/configuring-subsequent-processing-nodes.html