Status Report Virtual Attribute Does Not Get Displayed When Created ON Subsequent Lookup Attribute Creation

Products

• Clarity PPM SaaS

Issue/Introduction

The virtual attributes on a status report do not display when the same lookup is referenced.

STEPS TO REPRODUCE:

1. Create a CIT lookup attribute on a lookup attribute using example lookup =  'Department browse'
Set the API Attribute ID.

2.  On the Status Report object, create a VIRTUAL attribute referencing the same lookup above, using example Master Object, ex: project
Set the Attribute Label and Attribute ID.
Set the API Attribute ID.

3. Go to the project > Status > Configure > add the attribute.
The set lookup value is displayed.

4.  To create the issue,
on the Status Report object, create another  VIRTUAL attribute referencing the same lookup above, using example Master Object, ex: project
Set the Attribute Label and Attribute ID.
Set the API Attribute ID.

Expected: The latest attribute on the Status Report should display. 
Actual: The latest attribute on the Status Report does not display.

Resolution

This is reported as DE79932 and is working as designed.

The project workspace would display only the value for the virtual attribute derived from attribute of project.
The same behavior exists for ideas and CITs.