Spectrum AutoDiscovery Discovery and Modeling tabs are greyed out

Products

• CA Spectrum
• DX NetOps

Issue/Introduction

The customer has multiple AutoDiscovery configurations.

He noticed that sometimes when in the Discovery Console, when he clicks on a Discovery Configuration that has been run multiple times before, the Discovery and Modeling tabs are greyed out.

If he clicks on a different Discovery Configuration and then clicks back on the first configuration, the Discovery and Modeling tabs are not greyed out anymore.

Environment

Component: AutoDiscovery
Version: Any

Resolution

This issue has been reported to the DX NetOps team for debugging and resolution.

Additional Information

Work-around:

When seen, click on a different Discovery Configuration in the list and then click back on the Discovery Configuration where this is seen. You should not see the Discovery and Modeling tabs.