The tooltip of the Utilization Chart show inconsistent data

Products

• CA Automic Workload Automation - Automation Engine

Issue/Introduction

In AWI, under Administration > Automation Engine Management > Processes and Utilization, the tooltip that is shown when hovering over the bars shows inconsistent information.

Especially in the 24-hour view, it was not clear to which hour the bar was referring when comparing before and after midnight.

Environment

AWI

Cause

This is a defect

Resolution

Workaround:

Note that both in the chart and in the table views, the time columns represent a time range. For example, the 20:00 column represents the time range between 19:00 and 19:59.

 

Solution:

Update to a fix version listed below or a newer version if available.

Fix version:

Component(s): AWI

Automation.Engine 21.0.10 - Available
Automation.Engine 24.0.0 - Available

Additional Information

In the release notes this fix can be identified with the number AE-35279

Public description: An issue was fixed where the timestamp in the diagram of the processes and utilization tab was unclear.