Panvalet ISPF member level number doesn't increase after edit

Products

• Panvalet

Issue/Introduction

Update a member in Panvalet ISPF and save. It is expected that the level number of the member should increase noting an update has been done, but the level number does not change.

Cause

A new parameter was added to PSPIPOPT in 14.5  to not increase the level number until testing was done on the member. If it is set to N then updates do not happen. 

                             &SF060 = 'N' /* INCREMENT LEVEL # ON SAVE OF EDITED MEMBER

Resolution

Edit panel PSPIPOPT and change variable &SF060='N' to 'Y' so that level numbers will change on save.