BND7141I - Automatic DTF Switching message

Products

• Bundl
• View

Issue/Introduction

What is Automatic DTF Switching mentioned in the BND7141I message when the distribution job runs?

Environment

Component: View

Resolution

Automatic Switching is a process that Bundl uses to change the DTF that is defined to a report when it does not exist to a default DTF. The BND7138E message is issued to inform the administrator that the DTF was not found.

The "default" DTF record that Bundl will use for the switch is called (STANDARD) (STD). If the default DTF record is not defined, the following messages are issued:

BND7140I No DTF record (STANDARD) (DTF) exists.
BND7141I Automatic DTF switching disabled.

To prevent the BND7140I and BND7141I messages, define a DTF record with a Device ID = (STANDARD) and a mode of (DTF).

*Note - The parentheses are required*