S806 for module TMSSVC in the CA 11 RMS step

Products

• Workload Automation Restart Option for z/OS Schedulers (CA 11)

Issue/Introduction

When doing a job restart, getting S806 in the CA 11 RMS step for module TMSSVC

Resolution

S806 for TMSSVC occurs when the option CA-1 is still set to YES.  You will need to change options so that CA 1 is set to NO.  You can dynamically change the option without taking down CA 11.  Job AL7UOPT in the CAL7SAMP library would have to be run to change the CA 1 option value.  After AL7UOPT runs successfully, you will need to refresh the U11OPT option module to pick up the changes.  LLA refresh will also have to be done if CAILIB is in linlkist. To refresh the options issue the following DBAS command: 

comchar REFRESH MOD=U11OPT 

To verify the changes took place you can issue the following DBAS command: 

comchar DISPLAY OPTIONS