Data overlap is caused in MUX pages whenever a blueprint rule is triggered
search cancel

Data overlap is caused in MUX pages whenever a blueprint rule is triggered

book

Article ID: 276955

calendar_today

Updated On:

Products

Clarity PPM SaaS

Issue/Introduction

When users used a blueprint rule to show/hide modules using any Boolean attributes. However, the data gets overlapped for two seconds before the page loads.

Steps to Reproduce
1. log in as admin 
2. Go to projects 
3. Open any test Project & open the Properties module. (Make sure a blueprint rule is created at the project blueprint level for enabling and disabling modules)
4. When the user tries to enable the fields the page gets reloaded for 2 seconds displaying the data in a wrapped state(overlapping of data).

Expected Results: The page must load without overlapping data.

Actual Results: The user is getting overlapping of data in the Properties tab when any check box in the other modules is checked.

Environment

16.1.3

Cause

DE78313

Resolution

DE78313  is fixed and released on 16.2.1