NetOps Portal AppNeta Network Path item missing tag key:value pairs

Products

• CA Virtual Network Assurance
• DX NetOps

Issue/Introduction

DX NetOps Portal with Virtual Network Assurance (VNA) integrated and running the AppNeta Plugin

AppNeta Plugin not getting all tag Key:Value pairs

In AppNeta, you can set multiple tags on a network path...specifically you set multiple values for a key:

But when this data comes over to PM from VNA, we seem to show just the last value that is associated with a key:

Environment

All supported DX NetOps Virtual Network Assurance releases 23.3 and newer

Cause

In AppNeta, you can set multiple tags on a network path, specifically you can set multiple values for the same key/category. But when this data comes over to PM from VNA, only the last value that is associated with a key is displayed.

Resolution

VNA and DC code was updated to allow multiple values for same AppNeta key/category.

This will be resolved in 23.3.5. Upgrade to 23.3.5 or newer for code change that resolves this via defect ID DE586181.

Additional Information

Review the 23.3.5 Fixed Issues list, when available, to confirm inclusion of fixes for the defect DE586181.