Allocating new rules library / RULESET
search cancel

Allocating new rules library / RULESET

book

Article ID: 276211

calendar_today

Updated On:

Products

OPS/MVS Event Management & Automation

Issue/Introduction

I have just allocated a new PDS following the naming pattern of RULEPREFIX and RULESUFFIX. However, the new ruleset shows as DISABLED on panel 4.5.1.

Do I need to enable the entire ruleset? How to change the status of a ruleset to ENABLED?

Resolution

The status of a ruleset will be set to ENABLED when there is at least one rule enabled inside it.

You never need to enable the entire ruleset unless you want to enable ALL rules contained in that ruleset.