UIM - can ampgtw send data to two different destinations?

Products

• DX Unified Infrastructure Management (Nimsoft / UIM)

Issue/Introduction

This article explains how to configure apmgtw so it can send data to two different destinations. 

Environment

Release : 20.3

Cause

APMGTW by default can send data to only 1 destination.

 

 

Resolution

We had created a test build v3.24T9 for this particular use case.

There is no need to change or deploy this on the primary hub apmgtw. This build is for a secondary hub/robot where the probe configuration needs to be updated the same as the primary one. So that it can post the UIM data to some other APM environment. A detailed document has been attached to this case along with the test build 

Additional Information

This patch will be integrated with APMGTW in the next GA release