ForEach Workflow - Set a breakpoint in WF monitor and releasing it leads to that at each iteration the BP is set again
Article ID: 272453
Updated On:
Products
Issue/Introduction
Within the WF Monitor a breakpoint is set to one of the tasks. After releasing the breakpoint ForEach workflow iteration ends and new iteration begins, the breakpoint is set again, and in each following iteration.
Reproduction steps:
1. Create a ForEach Workflow with x iterations (more than 2) and several jobs in it (more than one)
2. Run the FE WF
3. While its active, set a breakpoint to a not yet active task within WF Monitor
4. Release/Delete the breakpoint
4.1 (12.3.4) The WF goes in next iteration, it should not show the breakpoint and run through all tasks.
4.2 (12.3.5 +) next iteration WF still stops, breakpoint stays in next cycle
Environment
Release : 12.3.4 and 12.3.5 +
Resolution
This is identified as BUG and will be fixed in next upcoming version.
Once it is fixed, this KBArticle shows the fixed version details.
Additional Information
AE-32772
Feedback
