RMA256E in Recovery Analysis
search cancel

RMA256E in Recovery Analysis

book

Article ID: 271640

calendar_today

Updated On:

Products

RC/Migrator for DB2 for z/OS

Issue/Introduction

When executing the DDL generated by an analysis with the Recovery option, error RMA256E occurs during Recovery Analysis.

RMA256E MODEL REQUESTED NOT FOUND. MODELID model CREATOR creator
  RECOVERY ANALYSIS COMPLETED, RETURN CODE =  16                  

The error may occur when the following is true:

1. The RCM model exists on the local subsystem.

2. The Compare strategy is comparing to a remote target subsystem.

3. The Userid used to submit the DDL for execution, is not the same Userid that was used to analyze the strategy.

Environment

Release : 20.0

Cause

When the DDL is executed through Batch Processor, the job submitter ID is used for authority. This ID is used to perform the Recovery Analysis, so in this case a different ID to that used for the Strategy Analysis.

Resolution

The submitter ID either needs to be SYSADM or granted authority to the RCM Analysis Plan (RCMAPLAN) on the local subsystem.