Post-upgrade to e2e_appmon v3.01 - wrong path in the Command window for running transaction scripts

Products

• DX Unified Infrastructure Management (Nimsoft / UIM)
• CA Unified Infrastructure Management On-Premise (Nimsoft / UIM)
• CA Unified Infrastructure Management SaaS (Nimsoft / UIM)

Issue/Introduction

Distributed e2e_appmon probe v3.01 to another VM.  The path is shown below.  The e2e scripts will not start automatically or on it’s own via the e2e probe until I manually change taskadmin.exe to TaskExec.exe.

I am able to get it working when I change it manually.

Environment

• Release: 20.3
• Upgrade from e2e_appmon* 2.51 or 2.52, to 3.01
• e2e_appmon v3.01
• e2e_appmon_dev v3.01

Cause

• small defect in e2e_appmon version 3.01

Resolution

• Attached to this KB Article is an updated version of e2e_appmon and e2e_appmon_dev with a fix for the pathing/.exe issue.
• After upgrade, now the field should be udated with ../../../../NimRecorder/Bin/TaskExec.exe instead of->  ../../../../NimRecorder/Bin/TaskAdmin.exe
• Its been tested and verified to fix the issue.

Additional Information

• Broadcom UIM development will merge it into the GA version as a minor change moving forward, but with this small change you can use the attached version(s).
  • e2e_appmon_dev-3.01-T1
  • e2e_appmon-3.01-T1